Buick 1993 Park Avenue Manuel du propriétaire Page 155

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 340
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 154
Press the PWR button or turn the ignition key
off
to stop
the disc player. The disc stays in the player and will
resume playing at the point where it stopped.
EJECT
Press EJCT, the disc will eject and the radio will play.
The disc will start at track
1
when you reinsert it.
As a feature to protect the disc,
if
you
turn
the ignition
off
with the disc partway out of the slot (after eject),
it
will
be
drawn back into the player
in
about
30
seconds. The disc
will play at track
1
when the radio is turned on again.
Anti-Theft Feature
Delco-Loc I1 is a security feature for the compact disc
player. It can be used or ignored.
If
ignored, the system
plays normally. If it is used, your player won’t be usable
if it’s ever stolen, because it won’t turn on.
The
instructions below
tell
you how to enter your
personal secret code into the system. If your vehicle loses
battery power for any reason, you must unlock the system
with the secret code again before the system will
turn
on.
Be sure to read through the entire procedure and become
familiar with
the
appropriate buttons and knobs before
starting.
Step
1.
Write clown any 6-digit number and keep it in a
safe place.
Step
2.
Turn the ignition to the ACC or RUN position.
Step
3.
Press PWR to
turn
the radio
off.
Step
4.
Press preset
1
and
4
buttons together. Hold them
until
“---”
shows on the display (at least
5
seconds).
You are now ready to enter your secret code. If you
pause more than
15
seconds between steps you may
have to start over.
Step
5.
Press SET and
“000”
will appear on the display.
Step 6. Press SEEK and hold
it
until the first digit of
your code appears.
Step 7. Rotate the tune knob right or left to make the
next two numbers agree
with
your code.
Step
8.
Press AM-FM knob and
“000”
will appear. Now
you are ready to enter the second three digits of the code
according to steps
6
and
7.
Step
9.
Press
the
AM-FM knob. The display will show
“rEP” for
5
seconds, and then
“OOO”
will appear indicating
that some steps are to
be
repeated for verification.
Step
10.
Repeat steps 6,7, and
8.
Step
11.
Press the AM-FM knob. If the display shows
“SEC”, the verification process was successful and the
system
is
SECURE. If
the
display shows
“---”,
the
verification steps were not successful and the entire
sequence must be started again.
Vue de la page 154
1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 339 340

Commentaires sur ces manuels

Pas de commentaire