Buick 2005 Century Manuel d'utilisateur télécharger pdf (Page 231)

1. Pull out the dipstick and wipe it with a clean rag or

paper towel.

2. Push it back in all the way, wait three seconds and

then pull it back out again.

3. Check both sides of the dipstick, and read the

lower level. The ﬂuid level must be in the

crosshatched area.

4. If the ﬂuid level is in the acceptable range, push the

dipstick back in all the way.

How to Add Fluid

Refer to the Maintenance Schedule to determine

what kind of transaxle ﬂuid to use. See Scheduled

Maintenance on page 6-4.

If the ﬂuid level is low, add only enough of the proper

ﬂuid to bring the level into the crosshatched area on

the dipstick.

1. Pull out the dipstick.

2. Using a long-neck funnel, add enough ﬂuid at the

dipstick hole to bring it to the proper level.

It does not take much ﬂuid, generally less than

one pint (0.5 L). Do not overﬁll.

Notice: Use of automatic transaxle ﬂuid labeled

other than DEXRON

-III, Approved for the

H-Speciﬁcation, may damage your vehicle, and the

damages may not be covered by your warranty.

Always use automatic transaxle ﬂuid labeled

DEXRON

-III, Approved for the H-Speciﬁcation.

3. After adding ﬂuid, recheck the ﬂuid level as

described under “How to Check,” earlier in

this section.

4. When the correct ﬂuid level is obtained, push the

dipstick back in all the way.

5-21

1 2 ... 226 227 228 229 230 231 232 233 234 235 236 ... 347 348

Pas de commentaire

Buick 2005 Century Manuel d'utilisateur Page 231