Buick ManageUPS Manuel d'utilisateur télécharger pdf (Page 11)

Rear Panel Description

8 ManageUPS

NET

User Instruction Manual

Table 2. Rear Panel Description

RXD Receive Data This LED ﬂashes when Ethernet packets are detected by the ManageUPS

NET

TXD Transmit Data This LED ﬂashes when ManageUPS

NET

transmits an Ethernet packet

LNK Link Integrity When lit, this LED indicates that the link integrity test pulse from the 10Base-T

hub/concentrator is good. Basically, a valid physical network connection has been

established.

RJ-45 Connector The RJ-45 jack provides the network connection to a 10Base-T Ethernet LAN.

This port should be connected to an Ethernet Hub/Concentrator with a cable no

longer than 100 meters in length. Category 3 type shielded twisted pair or better

patch cable is recommended.

RESET Switch The RESET opening provides access to a momentary push-button switch that

performs a hard reset of ManageUPS

NET

. Normally, this switch will never need to

be used. ManageUPS

NET

is designed with numerous hardware and software

features intended to keep the agent from locking. In the unlikely event that the

agent locks-up or appears to be malfunctioning, a paper clip can be used to press

the reset button through the access hole.

NOTE:

Resetting ManageUPS

NET

will clear all volatile object

values in the Agent. This includes MIB-2 management objects

like:

sysUpTime

snmpInPackets

upsInputLineBads

upsAlarmsPresent etc

If trap destination receiver(s) are conﬁgured, a Cold Start trap will be sent when a

reset is performed.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 66 67

Pas de commentaire

Buick ManageUPS Manuel d'utilisateur Page 11