Buick ManageUPS Manuel d'utilisateur télécharger pdf (Page 53)

Appendix D: SNMP MIBS

50 ManageUPSNET User Instruction Manual

upsOutput Group

upsOutputSource Supported values: normal(2), battery(4), booster(5).

upsOutputFrequency Measured average.

upsOutputNumLines Number of phases. This is one for single phase UPS’s.

upsOutputTable

upsOutputVoltage True RMS voltage measurement.

upsOutputCurrent The present output current.

upsOutputPower Represents actual output watts.

upsOutputPercentLoad Values from 0 to about 141% are supported.

upsBypass Group

Not Supported

upsAlarm Group

upsAlarmsPresent The current number of active alarms. After an alarm condition in

the UPS has gone away, it can take up to 1 minute for the alarm to

be removed from the alarm table.

upsAlarmTable

upsAlarmId The instance number of the alarm entry in the alarm table.

upsAlarmDescr The Object Identiﬁer (OID) corresponding to the alarm condition.

upsAlarmTime The value of sysUpTime when the alarm condition occurred.

upsWellKnownAlarms

upsAlarmBatteryBad UPS Battery needs replacing.

upsAlarmOnBattery UPS is running on battery power.

upsAlarmLowBattery Run time left is less than conﬁgured low battery alarm value.

upsAlarmDepletedBattery Run time is just about zero.

upsAlarmTempBad Temperature near the battery is too hot.

upsAlarmInputBad Utility power out of limits or not present.

upsAlarmOutputBad Not supported.

upsAlarmOutputOverload Output load power is > 100% of rated capacity.

upsAlarmOnBypass Not applicable.

Table 7. RFC1628 Support (Continued)

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 66 67

Pas de commentaire

Buick ManageUPS Manuel d'utilisateur Page 53